EGO correcion ?

Discuss VEMS and other standalone ECUs

EGO correcion ?

Postby 88a5tq » Wed Nov 09, 2016 4:49 pm

So very recently shortly after getting the car up and running I found that the ego correction wasn't showing as being lit as often as he used to be iirc. It's like the settings are correct but it doesn't appear to be shown as on as frequently in Idle as it used to be and it shows in the lack of Correction being done. Anyone else seen this with the new firmware and nightly build vemstune or the nightly build being used with a late 2014 fw?
Janitor at large
Image
1991 Audi 200 TQ HX35 (finally 56mm)
$500 butt-hurter
1988 Audi 5000 TQ
User avatar
88a5tq
 
Posts: 1482
Joined: Jul 16, 2014

Re: EGO correcion ?

Postby Colin2750 » Thu Nov 17, 2016 9:14 pm

The less that light is on, the better your tune is ;) lol
Colin2750
 
Posts: 95
Joined: Feb 28, 2013

Re: EGO correcion ?

Postby 88a5tq » Thu Nov 17, 2016 10:41 pm

Can't argue with that hah
Janitor at large
Image
1991 Audi 200 TQ HX35 (finally 56mm)
$500 butt-hurter
1988 Audi 5000 TQ
User avatar
88a5tq
 
Posts: 1482
Joined: Jul 16, 2014

Re: EGO correcion ?

Postby loxxrider » Fri Nov 18, 2016 11:06 pm

Maybe the tune is just better with your fresh engine
-Chris

'91 Audi 200 20v - Revver/BAT project
'91 Audi 200 20v Avant
'01 Anthracite M5
'90 M3
'85 Euro 635csi
'12 X3
E34 530i (maybe rear-mount soon)
User avatar
loxxrider
 
Posts: 6640
Joined: Feb 27, 2013
Location: Jupiter, FL / Somewhere, PA

Re: EGO correcion ?

Postby 88a5tq » Sat Nov 19, 2016 12:57 am

Ya that would be a nice ending to the story :)

I was just concerned when I looked down and noticed the lambda was rich at idle and looked up higher to see the ego bar said off. I have since gotten the table even better. It's amazing how much easier things are when using an engine that keeps all its fluids in their perspective places lol
Janitor at large
Image
1991 Audi 200 TQ HX35 (finally 56mm)
$500 butt-hurter
1988 Audi 5000 TQ
User avatar
88a5tq
 
Posts: 1482
Joined: Jul 16, 2014

Re: EGO correcion ?

Postby ChrisAudi80 » Tue Nov 22, 2016 2:13 am

*Respective.

Sorry...
96 S6 auto
95 80Q AEB VEMS
ChrisAudi80
 
Posts: 696
Joined: Mar 2, 2013
Location: Bangkok, Thailand

Re: EGO correcion ?

Postby 88a5tq » Tue Nov 22, 2016 7:19 am

Yep you're right
Janitor at large
Image
1991 Audi 200 TQ HX35 (finally 56mm)
$500 butt-hurter
1988 Audi 5000 TQ
User avatar
88a5tq
 
Posts: 1482
Joined: Jul 16, 2014

Re: EGO correcion ?

Postby 88a5tq » Tue Nov 29, 2016 4:50 pm

Btw I've figured this out. My reactivation cycles was 218 and I dropped it to 50 and it's back on now when I prefer
Janitor at large
Image
1991 Audi 200 TQ HX35 (finally 56mm)
$500 butt-hurter
1988 Audi 5000 TQ
User avatar
88a5tq
 
Posts: 1482
Joined: Jul 16, 2014

Re: EGO correcion ?

Postby audifreakjim » Tue Nov 29, 2016 5:13 pm

Glad you figured it out.
User avatar
audifreakjim
 
Posts: 1943
Joined: Mar 3, 2013

Re: EGO correcion ?

Postby ChrisAudi80 » Tue Nov 29, 2016 11:29 pm

88a5tq wrote:Btw I've figured this out. My reactivation cycles was 218 and I dropped it to 50 and it's back on now when I prefer

My reactivation delay is only 6 cycles. Is that too fast?
96 S6 auto
95 80Q AEB VEMS
ChrisAudi80
 
Posts: 696
Joined: Mar 2, 2013
Location: Bangkok, Thailand

Re: EGO correcion ?

Postby 88a5tq » Tue Nov 29, 2016 11:39 pm

Lol dang I wouldn't think so. I dropped mine again today to 20 but I was on the fence about lower
Janitor at large
Image
1991 Audi 200 TQ HX35 (finally 56mm)
$500 butt-hurter
1988 Audi 5000 TQ
User avatar
88a5tq
 
Posts: 1482
Joined: Jul 16, 2014

Re: EGO correcion ?

Postby Colin2750 » Wed Jan 04, 2017 12:33 am

I think mine is at 4. Less than 10 would be good
Colin2750
 
Posts: 95
Joined: Feb 28, 2013

Re: EGO correcion ?

Postby 88a5tq » Wed Jan 04, 2017 7:17 am

Thanks Colin, I did change to 6 not long go. I may go to 4 though.
Janitor at large
Image
1991 Audi 200 TQ HX35 (finally 56mm)
$500 butt-hurter
1988 Audi 5000 TQ
User avatar
88a5tq
 
Posts: 1482
Joined: Jul 16, 2014


Return to Standalone Engine Management

Who is online

Users browsing this forum: No registered users and 3 guests